Edwards Signaling eFSA250 User Manual
Page 134
Chapter 2: Front panel programming
122
E-FSA64 and E-FSA250 Technical Reference Manual
To program the CMS network (transmitter):
1. Display the panel configuration options menu. See
“Panel programming” on page 109.
2. Choose CMS Device.
3. Choose Network, and then select a network from
the list (1 through 8).
4. Program the network using the Table 34 on page
120. For network default settings, see “Factory
default settings” on page 36.
5. When you have finished programming each
option, choose Save.
6. Press the Menu button to exit menu mode, or
continue programming.
Panel Configuration
Ann. Class
Annunciator
CMS Device
CMS Device
Dialer
Network
Swngr Shtdn Rp. 200>
Network
Network 01
Network 02
Network 03
Network
Enabled Yes<>
Account ID 6769
IP 192.168.001.254
Network
Receiver# 0000
Line# 0000
Save
Printer programming
If a printer is connected to the system, you must set the printer type and
configure printer event notification options. This controls where printer trouble
events are sent and displayed. To communicate with a printer, you must install
the optional SA-232 module in the panel and connect it to a compatible serial
(RS-232) printer.
To program a printer:
1. Display the panel configuration options menu. See
“Panel programming” on page 109.
2. Choose Printer.
3. Choose Type.
4. Select the printer type.
Supervised: The printer connection is supervised
(refer to the printer’s switch settings)
Unsupervised: The printer connection is not
supervised
Panel Configuration
Annunciator
CMS Device
Printer
Printer
Type Supervised>
Event Notification
Save