Labeling devices – Edwards Signaling eFSA250 User Manual
Page 83
Chapter 2: Front panel programming
E-FSA64 and E-FSA250 Technical Reference Manual
71
To perform incremental programming:
1. Press the Menu button and choose Program.
2. Choose Incremental Program.
3. Enter a level two password.
4. Set the incremental programming options using
Table 23 on page 69.
5. When you have finished, press Enter.
The panel begins incremental programming and
displays the number of devices in the system. If
the panel has two loops, the device counts for
each loop are given separately. The system
displays the number of old and new devices.
6. Press Enter to continue.
Incremental programming continues based on the
settings you made above.
7. If you chose to label devices and/or zones, use the
procedures that follow to enter labels.
8. When incremental programming is complete, the
system returns you to the banner screen.
Main Menu
Reports
Test
Control
Program
Program
Incremental Program
Auto Program
Advanced Program
Enter Password
0000
Incremental Program
Loop Loop 1>
Label Devices No>
Label Zones No>
Auto Program
System Busy
################
<Back <Cancel
Devices Old/New
Loop 1 XXX/YYY
Loop 2 XXX/YYY
<Continue
— or —
Devices: Old/New
XXX/YYY
<Continue
Labeling devices
If you set the Label Devices incremental programming option to yes, follow this
procedure to label the devices.
To label devices:
1. Next to “Device,” enter the number of the device to
be labeled.
2. Enter a text label for the device (two lines of 20
characters). The default label is “Loop X Device
XXX.”
Loop 1 Device 001
Label goes here
Label continued
<Save <Back