Edwards Signaling eFSA250 - Manual (Page 240)

Appendix B: Worksheets
228 E-FSA64 and E-FSA250 Technical Reference Manual
Device settings worksheet
The device settings worksheet is used to document the configuration and
settings for each of the devices on the system.
Note: For default settings, “Factory default settings” on page 36.
Type of device
☐ Photo detector ☐ Photo/heat detector ☐ Heat detector
☐ Duct detector ☐ Ion detector ☐ Relay module
☐ NAC module ☐ Input module
Device address
Label Line 1
Label Line 2
Zone, if used
Correlation
groups
Day sensitivity
☐ Normal ☐ Least ☐ Less ☐ More ☐ Most
Night sensitivity ☐ Normal ☐ Least ☐ Less ☐ More ☐ Most
Day prealarm %
(Off, 50, 55, 60, 65, 70, 75, 80, 90)
Night prealarm % (Off, 50, 55, 60, 65, 70, 75, 80, 90)
Base type
☐ Standard ☐ Relay ☐ Isolator ☐ Sounder
Base follow ☐ Alarm ☐ Alarm + verify ☐ Alarm + prealarm
☐ Head ☐ None ☐ Riser (sounder bases only)
Type
☐
Smoke ☐ Duct alarm ☐ Remote reset
☐ Smoke verified ☐ Duct supervisory ☐ Remote drill
☐ Heat alarm ☐ Supervisory (latching) ☐ Remote signal silence
☐ Heat alarm RoR ☐ Supervisory (nonlatching) ☐ Remote AC fail
☐ Pull station ☐ Relay (nonsilenceable) ☐ Remote test station
☐ Waterflow ☐ Relay (silenceable) ☐ Continuous (nonsilencble.)
☐ Waterflow (retard) ☐ Genesis (silenceable) ☐ Continuous (silenceable)
☐ Monitor ☐ Genesis (nonsilenceable)