Show measured parameters, Show command help – Vaisala GMW90 User Manual
Page 43
Chapter 4 _________________________________________________________________ Operation
VAISALA ________________________________________________________________________ 41
Show Measured Parameters
Use the CALCS command to list the measurement parameters that are
supported by the GMW90 series transmitters. CO
2
, RH and T are
measured directly by the transmitter, the rest are calculated based on the
measured values.
CALCS<cr>
Example:
>calcs
RH - Relative Humidity
T - Temperature
Tdf - Dew/Frost point temperature
Td - Dew point temperature
Tw - Wetbulb temperature
h - Enthalpy
x - Mixing ratio
a - Absolute humidity
dTd - Dew/frostpoint depression
CO2 - Filtered CO2
NOTE
CALCS command also lists all humidity parameters, even if your
transmitter model does not measure humidity.
Show Command Help
To see a short description of an individual command, issue the command
with a question mark as a parameter.
Example:
>calcs ?
Display measured quantities