Vaisala GMW90 - Manual (Page 49)

Chapter 4 _________________________________________________________________ Operation
VAISALA ________________________________________________________________________ 47
Display Settings
Select Parameters to Display
Use the DSEL command to select the parameters that are displayed on
the transmitter screen. You can select parameters by abbreviation. If only
one parameter is selected, it is shown vertically centered on the
transmitter screen.
DSEL [Q1 Q2 Q3]<cr>
where
Q1 = First parameter to show on the screen. Available parameters
are:
out1 same parameter as analog output channel 1
out2 same parameter as analog output channel 2
out3 same parameter as analog output channel 3
CO2 carbon dioxide level
CO2_10 carbon dioxide level in 10 ppm steps
RH relative humidity
T temperature
Tdf dew/frostpoint temperature
Td dewpoint temperature
Tw wetbulb temperature
h enthalpy
x mixing ratio
a absolute humidity
dTd dew/frostpoint depression
Q2 = Second parameter to show on the screen. Available
parameters are the same as for Q1.
Q3 = Third parameter to show on the screen. Available parameters
are the same as for Q1.
Example (show currently displayed parameters):
>pass 9000
>dsel
Quant 1 : RH
Quant 2 : T
Quant 3 : CO2
Example (change display to only show CO2):
>dsel CO2
OK