Dakota Ultrasonics DFX-8 plus MANUAL1 - Manual (Page 110)

Dakota Ultrasonics
106
The procedures for enabling and adjusting the IM measurement mode are outlined
below:
Activating the (IM) Mode
1) Press the MENU key once to activate the menu items tab. Press the MENU
key multiple times to tab right and the ESC key multiple times to tab left until
the TUNE menu is highlighted and displaying the submenu items.
Alternatively, press the LEFT and RIGHT arrow keys multiple times
using the left button wheel.
2) Use the UP and DOWN arrow keys multiple times on the left button
wheel to scroll through the sub menu items until MEASURE MODE is
highlighted.
3) Use the LEFT and RIGHT arrow keys on the right button wheel to
toggle the MEASURE MODE.
4) Once the desired MEASURE MODE is displayed , press the MEAS key to
return to the measurement screen.
Note: Two gates will be enabled and can be adjusted using the Hot or Tabbed
Gate menu items. Refer to section 4.4 to adjust and configure the postion
of the gates.