Dakota Ultrasonics DFX-8 plus MANUAL1 - Manual (Page 62)

Dakota Ultrasonics
58
and RIGHT arrow keys multiple times using the left button wheel to scroll the
value. When the correct X-Offset is displayed, proceed to the next setting.
2) Alternatively, press the ENTER key to display the Digits Edit Box.
3) Press the UP and DOWN arrow keys multiple times on the left button
wheel to scroll the highlighted value.
4) Press the LEFT and RIGHT arrow keys multiple times using the left
button wheel to scroll the digit locations.
5) Repeat steps 3 & 4 until the X-Offset is correctly displayed.
6) Press the OK key to set the X-OFFSET and return to the menu screen, or
ESC to cancel entering the X-OFFSET.
Note: The X-Offset is used for purposes of marking, and is physically
measured with a ruler from the index point to the front edge of the transducer.
Curved Surface Outside Diameter
1) Press the UP and DOWN arrow keys multiple times on the left button
wheel until CSC OD is highlighted, followed by pressing the LEFT and
RIGHT arrow keys multiple times using the left button wheel to scroll the
value. When the correct CSC OD is displayed, proceed to the next setting.
2) Alternatively, press the ENTER key to display the Digits Edit Box.
3) Press the UP and DOWN arrow keys multiple times on the left button
wheel to scroll the highlighted value.
4) Press the LEFT and RIGHT arrow keys multiple times using the left
button wheel to scroll the digit locations.
5) Repeat steps 3 & 4 until the CSC OD is correctly displayed.