INFICON XTM/2 Thin Film Deposition Monitor - Manual (Page 121)

6 - 19
IP
N 07
4-
18
6S
XTM/2 Operating Manual
6.4.5 Crystal Snatcher
To use the crystal snatcher supplied with the sensor follow the instructions
below (see
Figure 6-6 ):
1 Insert crystal snatcher into ceramic retainer (1) and apply a small amount of
pressure. This locks the retainer to the snatcher and allows the retainer to
be pulled straight out (2).
2 Re-insert the retainer into the holder after the crystal has been changed.
3 Release the crystal snatcher with a slight side-to-side motion.
Figure 6-6 Use of Crystal Snatcher