Kinze 3200 Wing-Fold Planter Rev. 7/14 - Manual (Page 109)

TM
Model 3200 M0241-01
6/11 6-19
KPM II Monitor Operation
STEP 6 If the monitor system includes shaft rotation sensors, these should be installed at this time. Plug in the L.H. shaft first, then the
R.H. shaft. L.H. and R.H. is determined by facing in the direction the machine will travel when in use.
“LSHAFT” or “SHAFT 1” will display on the lower LCD when the first shaft rotation sensor is installed. “RSHAFT” or “SHAFT 2”
will display when the second shaft rotation sensor is installed.
NOTE: Illustrated using rear/front configuration. The KPM II Stack-Mode console shows LEFT in the left/right configuration, REAR
in the rear/front configuration and FRONT LEFT/REAR LEFT in the four sections configuration.
ON
AREA
OFF ExIT
ENTER
OK
CLEAR
SETUP
ROW
SPACING
TOTAL
AREA
UNITS
SPEED
VOLUME
SCAN
SEED
POPULATION
SEED
SPACING
FIELD
AREA
SPACING TOTAL
SEED
POP. FIELD
SELECT SPEED SCAN
SETUP
SETUP
REAR
1
REAR
12 11 10 9 8 7 6 5 4 3 (2 13 14 15 16 17 18)
(FRONT)
FLASHING
®
KPM II •
ON
AREA
OFF ExIT
ENTER
OK
CLEAR
SETUP
ROW
SPACING
TOTAL
AREA
UNITS
SPEED
VOLUME
SCAN
SEED
POPULATION
SEED
SPACING
FIELD
AREA
SPACING TOTAL
SEED
POP. FIELD
SELECT SPEED SCAN
SETUP REAR
12 11 10 9 8 7 6 5 4 3 2 1 (1314 15 1617 18)
(FRONT)
FLASHING
SETUP
REAR
®
KPM II •