Programming/connecting seed tubes -4, Kpm i monitor operation – Kinze 3200 Wing-Fold Planter Rev. 7/14 User Manual
Page 94
M0241-01
Model 3200
6-4
6/11
TM
KPM I Monitor Operation
STEP 5 Plug each seed tube w/sensor into the harness in a
predetermined order. Row 1 first, row 2 second and
so on up to 18 rows. When a sensor is plugged in,
the corresponding row number on the LCD display
will stay solid, the monitor will chirp twice and the
LED (Light Emitting Diode) on the seed tube sensor
will turn on for approximately 30 seconds to show
connection is made. NOTE: Unless there is a faulty
sensor, the installer should just have to connect the
sensors in the proper order without checking the
monitor is acknowledging each sensor.
®
STEP 4 Press and hold the OK key to confirm selection
and continue holding until row numbers display.
During confirmation, the display alternates between
“NEW” and “SYS” to alert the user that the previous
configuration will be lost. With rear/front mode
selected, the monitor automatically starts with the
rear section. The REAR icon shows solid and the
FRONT icon starts to flash. With the left/right mode
selected, the monitor automatically starts with the left
section. The LEFT icon shows solid and the RIGHT
icon starts to flash.
®
®
®
®
PROGRAMMING/CONNECTING SEED TUbES
STEP 1 All seed tubes w/sensors must be disconnected from
the harness and monitor must be off.
STEP 2
Press ON key. The monitor automatically enters the
setup procedure. If the monitor was accidentally
powered on with no sensors attached, the user can
turn the monitor off at this point and the previous
configuration is not lost.
STEP 3 Press SELECT key. Each time you press the SELECT
key the mode toggles between rear/front and left/
right. The selected display will be solid and the
configuration not currently selected will be flashing.
By default the monitor starts in rear/front mode.
NOTE: Model 3000 planters use rear configuration only.
When Interplant Package rows are in use, select rear/front
configurations. When all rows can be viewed on a single
display (rear), pressing the select key has no function.