Kinze 3200 Wing-Fold Planter Rev. 7/14 - Manual (Page 22)

M0241-01 Model 3200
2-10 6/11
TM
Machine Operation
NOTE: Hydraulic pressure will prevent selector valve from
moving. Release hydraulic pressure from system before
attempting to move selector valve handle.
2. Move selector valve to “FOLD”.
3. Move the tractor hydraulic control and fold the wings out to
operating position.
Selector valve
1. With planter raised and cylinder lockups in place, remove
wing lock pins at marker support and hitch. Fold wings out
to operating position.
NOTE: If wing lift tires are not raised, with cylinder lockups
in place on four center section lift cylinders, move tractor
hydraulic control to lowering position until cylinders are fully
retracted and wing tires are fully raised.
4. Swing wing lock eyebolts into position to lock each wing.
5. Operate the hydraulic lever to extend the lift cylinders. (Wing
wheel cylinders may not fully extend)
6. Remove four center section cylinder lockups from cylinders
and place them in wheel module storage positions.
7. Lower planter. Hold tractor hydraulic control 5 to 10 seconds
with cylinders fully retracted to rephase system.
8. Tighten wing lock 1¼" hex nuts.
Wing lock pin locations
9. Release center turnbuckle and raise upright. Secure in
position with lockup pin.
NOTE: Hydraulic pressure will prevent selector valve from
moving. Release hydraulic pressure from system before
attempting to move selector valve handle.
10. Move selector valve to “MARKER”.
Center turnbuckle lockup pin
Securing wing lock eyebolt