Kinze 3200 Wing-Fold Planter Rev. 7/14 - Manual (Page 144)

M0241-01 Model 3200
7-4 6/11
TM
Lubrication and Maintenance
GREASE FITTINGS
Lubricate parts equipped with grease fittings at frequency indicated with an SAE multipurpose grease. Clean fitting
thoroughly before using grease gun. Frequency of lubrication recommended is based on normal operating conditions.
Severe or unusual conditions may require more frequent attention.
NOTE: Numbers on illustration below correspond to photos on following pages showing lubrication
frequencies.
Model 3200 12 row 30" planter shown
WHEEL bEARINGS
All drive, transport, and marker hub wheel bearings should be repacked annually and checked for wear.
1. Raise wheel off ground.
2. Check for bearing endplay by moving wheel side to side.
3. Rotate wheel to check for bearing roughness. If bearings sound rough, remove hub and inspect bearings.
NOTE: To repack wheel hubs, follow procedure outlined for wheel bearing replacement with exception that
bearings and bearing cups are reused.