Kinze 3200 Wing-Fold Planter Rev. 7/14 - Manual (Page 111)

TM
Model 3200 M0241-01
6/11 6-21
KPM II Monitor Operation
STEP 9 Follow STEPS 6, 7 and 8 to install the second, third and fourth sections (If Applicable). If no seed tubes are installed on the
additional sections, press and hold the OK key. “DONE” appears on upper display. Alarm sounds four short beeps followed by
one long beep and SAVE? icon turns off. The monitor has exited the setup mode. When you release the OK key upper display
scrolls “WAITING CALIBRATION”. Lower display shows “GNDSPD” and alarm sounds continually until distance sensor is
connected. See STEP 10.
NOTE: SMM console LCD remains blank (except the backlighted screen) until entire system is saved.
NOTE: Illustrated using rear/front configuration. The KPM II Stack-Mode console shows LEFT in the left/right configuration, REAR
in the rear/front configuration and FRONT LEFT/REAR LEFT in the four sections configuration. The SMM console shows RIGHT in
the left/right configuration, FRONT in the front/rear configuration and FRONT RIGHT/REAR RIGHT in four sections configuration.
® ®
®
®