Level planter, Level planter -6 – Kinze 3200 Wing-Fold Planter Rev. 7/14 User Manual

Page 18

background image


Model 3200




Machine Operation

5. Connect ASABE Standards 7 terminal connector for safety/warning lights on planter to ASABE Standards

receptacle on tractor. If your tractor is not equipped with an ASABE Standards receptacle, check with your tractor

manufacturer for availability. Check warning lights on planter work in conjunction with warning lights on tractor.

NOTE: A 12 volt battery connection is required to power the vacuum fan digital gauge. Connect
“red” wire to positive (+) battery terminal and “black” wire to negative (-) battery terminal.

6. Raise jack stand and remount horizontally on storage bracket.


Jack stand in stored position

Lateral adjustment is maintained by tire pressure. Check tires are inflated to specification.

Front and rear level adjustment is maintained by hitch clevis position unless tractor drawbar is adjustable for height.
Planter frame and row unit parallel arms must be level for proper planter and row unit operation. Bottom of toolbar
should be 20" to 22" from planting surface.

1. Lower planter to planting position and check planter is level front to rear. Go to step 2 if hitch is too high or low.

NOTE: DO NOT install safety chain using clevis hardware. Move safety chain location if necessary.

2. Remove clevis hitch hex head cap screw and lock nut using a torque wrench. Replace if off-torque is below

75 ft-lb (101.6 N-m) or there is corrosion or damage.

NOTE: Clevis must be free to move on hitch. DO NOT OVERTIGHTEN hardware.

3. Align clevis to hitch holes at new location and install hex head cap screw and lock nut. Tighten lock nut until

threads are fully engaged and hex head cap screw and lock nut are firmly against hitch bracket.

4. Recheck with planter in field.


Level planter

Same distance from ground.