Kinze 3200 Wing-Fold Planter Rev. 7/14 - Manual (Page 112)

M0241-01 Model 3200
6-22 Rev. 7/12
TM
KPM II Monitor Operation
NOTE: SMM console may not be applicable to
all models.
®
®
NOTE: To reprogram the system to monitor more or less
rows (up to the maximum of 18 per section, 72 total in four
section configuration), all sensors must be unplugged,
followed by the complete setup procedure.
NOTE: Individual seed tubes may be unplugged for special
situations. An alarm will sound which can be silenced by
touching the OK key. The monitor will recognize the seed
tube(s) when reconnected.
®
SMM
120
110
100
90
80
70
60
%
11 10 9 8 7 6 5 4 3 2 1
FRONT
ON
AREA
OFF ExIT
ENTER
OK
CLEAR
SETUP
ROW
SPACING
TOTAL
AREA
UNITS
SPEED
VOLUME
SCAN
SEED
POPULATION
SEED
SPACING
FIELD
AREA
SPACING TOTAL
SEED
POP. FIELD
SELECT SPEED SCAN
MPH
120
110
100
90
80
70
60
%
11 10 9 8 7 6 5 4 3 2 1
®
12
REAR
KPM II •
STEP 10 With the lower display showing “GNDSPD”, connect the distance sensor. The monitor will display “PICKUP” if a magnetic distance
sensor is connected or “RADAR” if a radar distance sensor is installed. Only one distance sensor can be connected at a time.
NOTE: To connect the radar distance sensor, install the 10" monitor/radar adapter between the console and radar distance sensor
to adapt the monitor system to various tractor radar systems. DO NOT CONNECT 10" MONITOR/RADAR ADAPTER PRIOR TO THIS
STEP.
NOTE: Illustrated using rear/front configuration. The KPM II Stack-Mode console shows LEFT in the left/right configuration, REAR
in the rear/front configuration and FRONT LEFT/REAR LEFT in the four sections configuration. The SMM console shows RIGHT in
the left/right configuration, FRONT in the rear/front configuration and FRONT RIGHT/REAR RIGHT in four sections configuration.