Kinze Ag Leader Integra User Manual
Page 122
106
Firmware Version 5.2
•
Note: If using OmniSTAR, see
• Differential Source
Select choice of WAAS/EGNOS, Satellite (OmniSTAR®) or Beacon (Coast Guard) differential sources.
• Wrench button
Pressing the Wrench button opens different settings screens, depending on whether you are using
OmniSTAR® or Beacon.
• Ignore NMEA Checksum
Check this to ignore intermittent GPS message errors.
• GPS Rate (Hz)
The GPS Position Rate drop-down menu represents the cycles per second that the display receives
guidance information from viewable satellites. Select one of the available Hz rates from the drop-down
menu.
• Age of Differential
Displays the elapsed time since reception of last differential correction signal. The Age of Differential button
is only functional when GPS is connected.
• Port Settings
Displays the Serial Port Settings screen, where you can adjust GPS output. For more information, see
“Serial Port Settings” on page
• Force TSIP Connection
Forcibly connects to TSIP GPS receiver. Pressing this button will force the port to TSIP communication.
• Reset to Defaults
Press the Reset to Defaults button to restore receiver settings to the factory default. This will remove all
custom settings.
Port
Settings
Force TSIP
Connection
Reset to
Defaults
Ignore NMEA
Checksum
WAAS
Backup
WAAS
Differential Source
GPS Rate (Hz)
1
Age of Differential
0
GPS Settings