Kinze Ag Leader Integra - Manual (Page 177)

161
P
LANTING
A
UTO
S
WATH
C
HECKING
A
UTO
S
WATH
P
ERFORMANCE FOR
R
OW
S
HUTOFF
The settings given in the above AutoSwath look-ahead table shown previously have been tested with
each clutch and seed meter combination to work for your planter. However, always take the time to
check for proper seed placement in the field and make system setting adjustments as needed. Do not
rely solely upon the appearance of the On-Screen map. The on screen map will not show gaps and
overlaps caused by incorrect GPS Offsets or AutoSwath Look-Ahead settings. Verify settings with the
following procedure:
1. Stop the planter within 20 feet of the planted headland.
2. Select one row unit from each planter swath section to observe.
3. Remove the down pressure from the closing wheel of each selected row unit.
4. Hold the closing wheels off the ground by attaching a chain or strap from the hopper support panel to
the closing wheel arm. (This prevents the closing wheels from closing the seed trench).
Securing these closing wheels up allows you to observe the planted seed in the trench so that you can
observe when the AutoSwath is turned off and on during the seed application.
5. Resume planting in your normal fashion, then stop when you are 20 feet out of the headland of the
next pass.
6. Stop the planter and observe the AutoSwath shutting off and turning on to see if the results are
acceptable.
• If the results are correct, then return the closing wheels to their previous operational state. Close the seed
trench on the observed rows and return to planting.
• If you suspect the results are incorrect, then adjust the appropriate look-ahead setting one-tenth (.1)
second per trial. When making changes to the look-ahead settings, make sure to adjust these settings
only one-tenth (.1) second per trial. Larger adjustments can cause unintentional large changes in the
AutoSwath’s performance. When adjusting the look-ahead numbers from the suggested settings, it is
recommended that you observe multiple trials to confirm the operations’ accuracy.
• If you encounter overplanting or underplanting problems, see “Fixing Overplanting and Underplanting in
AutoSwath” on page 161 .
F
IXING
O
VERPLANTING AND
U
NDERPLANTING IN
A
UTO
S
WATH
AutoSwath Function — Turn Off Look Ahead
Problem — Underplanting
Recommended Action — Decrease look-ahead number
Result — The AutoSwath anticipates headlands later and turns the planter off later.
Problem — Overplanting
Recommended Action — Increase look-ahead number
Result — The AutoSwath anticipates headlands sooner and turns the planter off sooner.
AutoSwath Function — Turn On Look Ahead
Problem — Underplanting
Recommended Action — Decrease look-ahead number
Result — The AutoSwath anticipates headlands later and turns the planter on later.
Problem — Overplanting
Recommended Action — Increase look-ahead number