Kinze Ag Leader Integra - Manual (Page 288)

272 Firmware Version 5.2
R
UN
C
ONFIGURATION
Once a configuration has been completed, the Map View button appears at the bottom of the
Home screen. Press the Map View button to see the Map screen.
Engage button
If the NORAC UC5 Boom Height Control is included in your Operating Configuration, then
the NORAC Engage button appears on the display’s Task Bar. The Engage button enables
boom height control. This button is green when the NORAC UC5 system is engaged; and
grey when disengaged. Press on this button to engage and disengage the NORAC UC5
Boom Height Control.
This button can be used to toggle back and forth between Automatic Mode and Manual Mode.
• When you enable Automatic Mode, this button turns green and the display beeps three times.
• When you disable Automatic Mode on any part of the boom and the display switches to Manual Mode,
this button turns white and the display beeps twice. If less than the full boom remains in Manual Mode,
the display will continue beeping twice every three seconds.
Boom Height Control Options Button
At the center of the Map screen’s
Equipment Tab, the Boom Height
Control Options button displays data on
NORAC UC5 Run Time performance.
• The Boom Icon appears as blue when in Automatic Mode; and black when in Manual Mode. The right, left
and center sections appear independently on this icon. Press the Boom Height Control Options button
to open the Boom Height Control Options screen. For more information, see
“Boom Height Control
Options Screen” on page 273 .
• The white arrows indicate the direction that the boom section is being commanded to move. The arrows
shown around the boom appear either 1) In Automatic Mode, or 2) When the boom is in Manual Mode
and the boom is moved by the operator.
• Mode
Indicates whether the Boom is in Crop Mode or Soil Mode. For further explanation, see
“Boom Height
Control Options Screen” on page 273 .
• Target Height
The desired boom height above the ground (for Soil Mode), or the crop canopy (for Crop Mode).
• Sensitivity
Adjusts the boom response. Higher values make the height control more responsive.
• Distance Between Boom and Target
The numbers that appear below the Boom Icon show the distance between the boom section and the target.
• Temperature
Shows the measurement of the outside ambient air temperature.
Mode: Crop Target Height: 12 in Sensitivity: 5
15.9 8.4 8.4 50 F