Rate control, Hydraulic seed rate control, Ontrol – Kinze Ag Leader Integra User Manual

Page 179: Ydraulic

Advertising
background image

163

P

LANTING

R

ATE

C

ONTROL

P

LANTING

R

ATE

C

ONTROL

H

YDRAULIC

S

EED

R

ATE

C

ONTROL

The Hydraulic Seed Control Module allows operators to control up to three hydraulic motor drives with
the display. Configure the Hydraulic Seed Rate Control module in the following order.

1. Configure Hydraulic Seed Rate Control module

See “Create Planting Configuration” on page

155.

2. Enter Controller Settings

Include the Max Meter Speed, Gear Ratio and Minimum Allowable Ground Speed. See

“Controller Settings

for Hydraulic Seed Rate Motor Drives” on page

163

.

3. Prime the Hydraulic Seed Meter

Fill seed meter with seed to avoid skips. See

“Priming Seed Rate Meters” on page

173

4. Meter Calibration

- a. Enter Meter Calibration Number. This number, representing seeds per revolution, is set according to

the number of seed dropped per one revolution of the seed meter. For more information,

“Calibrating

Seed Rate Meters” on page

174

- b. Perform a Seed Meter Calibration. A new calibration should be performed if as-applied seed rate

does not match actual population planted. See,

“Calibrating Seed Rate Meters” on page

174

C

ONTROLLER

S

ETTINGS FOR

H

YDRAULIC

S

EED

R

ATE

M

OTOR

D

RIVES

After creating an Operating Configuration for the Hydraulic Seed Meter Controller, make settings
changes in the Controller Settings screen, which shows valve settings for hydraulic flow and pulses per
revolution.

Press: Home button > Setup (wrench) button > Configuration (tractor) button > Configuration tab > your
specific configuration > Setup (wrench) button > Controller Settings button

The Controller Settings screen consists of at least two tabs: the Channel Tabs, shown for each channel
being controlled; and the Auxiliary Tab.

Configuration

Select Your Specific

Configuration

Controller

Settings

Advertising