Select pattern, Create ab line using driven path, Select pattern create ab line using driven path – Kinze Ag Leader Integra User Manual
Page 139
123
G
UIDANCE
Select Pattern
Press: Map button > Guidance tab (in Mapping Toolbox) > New Pattern button > Pivot Pattern Selection
System defaults pattern type to last used. Press the pattern icon to select a different pattern.
- Implement Width (from Implement Setup)
- Guidance Width input box
- Manual Entry checkbox and Latitude and Longitude input boxes
Press
. You will automatically return to the Map screen.
Create AB line using driven path
• Position one wheel of the vehicle in a pivot wheel rut, with the rear of the vehicle to the pivot arm.
•
Press to mark point A. A green ball appears on the map screen where point was
placed.
• Drive around the field. Keep the vehicle wheel in the rut.
•
Button is greyed out until you drive a minimum of 160 feet.
- Pause - Press
to pause path during path creation
- Resume - Press
to resume path during path creation
- Cancel - Press
to cancel path during path creation
•
When you are almost back to the pivot arm or the edge of the field, press to mark
point B., the AB line appears on the map screen and point B is marked with a red ball.
1. Next, you must set the Field Edge. You may do
this when the Pivot Field Edge window appears on
your display.
From here, you may choose one of three options:
New
Pattern
Inches
Shift By
Distance
Outward
Pivot Field Edge
Feet
0 ft
30 in
Inward