Priming an injection pump, Beginning with step 3 on, After – Kinze Ag Leader Integra User Manual

Page 267: Pplication

Advertising
background image

251

A

PPLICATION

I

NJECTION

7. Enter Actual Dispense Amount

Enter in the actual amount of the product that was dispensed. Press

to continue.

8. Calibration Complete

The Pump Calibration number appears. The New Injection Pump Calibration Number now appears in the
Pump Calibration screen. From this point, you may either:

• Repeat the calibration by pressing the Repeat Calibration button.

• Press

to complete the calibration and exit the Pump Calibration Wizard.

9. Calibration Displayed on Controller Settings
screen.
The new Injection Pump Calibration Number (A) now
appears in the Pump Calibration screen.

Priming an Injection Pump

If you are using a Direct Injection configuration, you must prime the Injection Pump each time you flush
or refill a tank, or change products. This ensures that air is not in the product lines.

CAUTION: Failure to perform this priming procedure before beginning a Direct Injection application could
result in skips at the start of field operations.

1. Press Injection Control button
To prime the Injection Pump, first go to the Map screen. Press the Injection button. The Injection
button is located at the left-hand side of the Equipment Tab. The Injection Controls screen
appears.

2. Press the Prime button

At the Injection Controls screen, press the Prime button.

• You may agitate the Direct Injection tank by pressing
the Agitate button. Once pressed, this Agitate setting
will continue even after the Priming process is finished,

until you press

a second time. To determine if a

product should be agitated, check the product
specifications.

• In order for a Direct Injection tank to agitate the
product, you must set the agitator motor switch on Run
(which agitates the product continuously) or Pulse
(which agitates the product intermittently).

Controller Settings

Pump Calibration

Factory

Calibration

11 pls/fl oz

Perform

Calibration

11 pls/fl oz

Rate Response Warning

Error

Threshold

Error Delay

5 s

30 %

Flow Monitor Warning

25 %

Error

Threshold

Enable Warning

Active Calibration

Injection

1

Injection Controls

Injection

Prime

Agitate

Advertising