Tank mix setup, Configuration setup, Onfiguration – Kinze Ag Leader Integra User Manual

Page 236: Etup

Advertising
background image

220

Firmware Version 5.2

Tank Mix Setup

A tank mix can contain up to seven individual components.

1. Select Tank Mix from the list box and press

to continue.

2. Enter a Base Amount and Units.

Note: The Base Amount is the total volume of all the components of the tank mix. The Base Amount does
not need to match the actual volume of product that will be sprayed, but is used only to establish the ratio of
all products to the total volume.

3. Press

to start the process of adding components to the tank mix. Select a desired mix

component from the list box (or press

to set up the product). Enter the Amount of the mix

component.

4. Repeat this process for the second mix component, if necessary.

5. Add a product carrier and an amount for that carrier by following the steps shown in the wizard.

6. Last, enter a unique name for the tank mix. The new mix will appear in the Product List. The
mix name will appear next to a blue and cream-colored “Tao” symbol (a circle with a curved line
through it).

C

ONFIGURATION

S

ETUP

Press: Home button > Setup (wrench) button > Configuration (tractor) button > Configuration tab > your
specific configuration > Setup (wrench) button

The Configuration Setup screen appears. Screen
will vary depending on configuration. Process may
include the following tasks:

Configuration Settings:

• Adjust Implement Switch Settings (for area logging)
If using an implement switch in a area logging planting operation, adjust the Implement Switch Settings. For
more information, see

“Equipment Settings” on page

79

.

• Adjust Equipment Settings (for Rate Control)
DirectCommand configurations should adjust settings at the Equipment Configuration Settings screen. For
more information, see

“Equipment Settings” on page

79

.

Configuration

Select Your Specific

Configuration

80 ft

Vehicle
Offsets

Norac

UC5

Crop

Sensor

Speed

Input

Auxiliary

Input

Automatic

Swath Control

Equipment

Settings

Calibrate
Pressure

Controller

Settings

Offsets

Implement: JD 4630

Full Swath:

Sections:

5

Controller: DirectLiquid

Serial Number:

2003750001

Device:

DirectCommand

Type:

Liquid

Flow Meter Cal (pls/gal)

inf

Vehicle

JD 4630

1

2

Configuration Setup

Advertising