Lenze EMF2141IB - Manual (Page 67)

Parameter setting
6-45
L
BA2141 EN 1.0
Network variable to drive
The function block AIF-IN determines the input data of the controller as data interface for the 2141
fieldbus module. For more detailed information about the function block AIF-IN, see the Manual
93XX.
AIF-IN.W1 to AIF-IN.W3 depend on the signal configuration selected under C0005.
Speed setpoint: 100 % = 16383
•
nviAIFStw = AIF-CTRL.B0 ... AIF-CTRL.B15 (control word)
Control word
LOW byte HIGH byte
Bits 0 to 7 of the control word will be entered here. Bits 8 to 15 of the control word will be entered here (see chapter
6.5.4.2)
The description of the bits can be obtained from the Code Table.
•
nviAIFIn1 = AIF-IN.W1
•
nviAIFIn2 = AIF-IN.W2
•
nviAIFIn3 = AIF-IN.W3
AIF-IN.Wx
LOW byte HIGH byte
Signal configuration (L-C0005) AIF-IN.W1 AIF-IN.W2 AIF-IN.W3 AIF-IN.D1
Speed control 1003 / 1013 /
1113
NSET-N
Speed setpoint
100 % = 16383
Torque control 4003 / 4013 /
4113
MCTRL-MADD
Torque setpoint
100 % = 16383
not assigned
DF master 5003 / 5013 /
5113
NSET-N
Speed setpoint
100 % = 16383
DF-slave bus 6003 / 6013 /
6113
DFSET-A-TRIM
Phase trimming DFSET-N-TRIM
Speed trimming
not assigned not assigned
DF-slave cascade 7003 / 7013 /
7113
DFSET-VP-DIV
DF factor DFSET-A-TRIM
Phase trimming
not assigned not assigned
Cam profiler 1xxx3 NSET1-FACT
Positioning 2xxx3 not assigned
vector control 1xx3 / 2xx3 / 3xx3
/ 5xx3 / 100x3
NLIM-IN1 not assigned
vector control 4xx3 NCTRL-MADD
vector control 6xx3 DFSET-A-TRIM DFSET-N-TRIM
vector control 7xx3 / 8xx3 / 9xx3 DFSET-VP-DIV DFSET-A-TRIM
vector control 100x3 NLIM-IN1
not assigned
vector control 110x3 not assigned
not assigned
Show/Hide Bookmarks