Lenze EMF2141IB - Manual (Page 9)

Safety information
2-1
L
BA2141 EN 1.0
2 Safety information
2.1 Persons responsible for the safety
Operator
• An operator is any natural or legal person who uses the drive system or on behalf of whom the drive system is used.
• The operator or his safety personnel is obliged
– to ensure the compliance with all relevant regulations, instructions and legislation.
– to ensure that only skilled personnel works on and with the 2102IB fieldbus module.
– to ensure that the personnel has the Operating Instructions available for all corresponding works.
– to ensure that all unqualified personnel are prohibited from working on and with the drive system.
Qualified personnel
Qualified personnel are persons who - because of their education, experience, instructions and knowledge about corresponding standards and regulations, rules for the
prevention of accidents and operating conditions - are authorized by the person responsible for the safety of the plant to perform the required actions and who are
able to recognize potential hazards.
(Definition for skilled personnel to VDE105 or IEC364)
2.2 General safety information
• These safety notes do not claim to be complete. In case of questions and problems please contact your Lenze representative.
• At the time of delivery the fieldbus module meets the state of the art and ensures basically safe operation.
• The indications given in these Operating Instructions refer to the stated hardware and software versions of the fieldbus modules.
• The fieldbus module is hazardous if:
– unqualified personnel works on and with the fieldbus module.
– the fieldbus module is used inappropriately.
• The processing notes and circuit sections shown in these Operating Instructions are proposals which cannot be transferred to other applications without being
tested and checked.
• Ensure by appropriate measures that neither personal injury nor damage to property may occur in the event of failure of the fieldbus module.
• The drive system must only be operated when no faults occur.
• Retrofittings, modifications or redesigns are basically prohibited. Lenze must be contacted in all cases.
• The fieldbus module is electrical equipment intended for use in industrial high-power plants. The fieldbus module must be tightly screwed to the corresponding
controller during operation. In addition, all measures described in the Operating Instructions of the controller used must be taken. Example: Fastening of covers to
ensure protection against contact.
Show/Hide Bookmarks