Lenze ETMD Tmd frequency inverter - Manual (Page 3)

2 ENGLISH
About these instructions
This documentation applies to the Tmd vector frequency inverter, and contains important technical data
and describes installation, operation, and commissioning.
These instructions are only valid for Tmd frequency inverters with software rev 11 (see drive
nameplate).
Please read the instructions before commissioning.
© 2004 Lenze AG
No part of this documentation may be copied or made available to third parties without the explicit written approval of
Lenze AG.
All information given in this documentation has been carefully selected and tested for compliance with the hardware and
software described. Nevertheless, discrepancies cannot be ruled out. We do not accept any responsibility nor liability for
damages that may occur. Any necessary corrections will be implemented in subsequent editions.
Scope of delivery Important
• 1 Tmd vector inverter (ETMD...)
with EPM installed (see Section 4.2)
• 1 Operating Instructions
After receipt of the delivery, check immediately whether the items
delivered match the accompanying papers. Lenze does not accept
any liability for deficiencies claimed subsequently.
Claim
• visible transport damage immediately to the forwarder.
• visible deficiencies/incompleteness immediately to your Lenze
representative.
A Certifications
B Type C Input Ratings
D Output Ratings E Hardware Version
F Software Version
A B C D E F
Type: ETMD152L4TXA
Id-No: 00000 000 Input: Output:
Made in USA
3/PE
AC 400/480 V
4.8 / 4.0 A
50 / 60 Hz
3/PE
AC 400/480 V
4.1 / 3.4 A
1.5 kW
0 - 240 Hz
For detailed information refer to
instruction manual TD03
004605460364930305
ETMD152L4TXA000XXXX
IND CONT EQ
Tmd011