Rockwell Automation 2706 DL40 HARDWARE USER MANUAL - Manual (Page 122)

Chapter
11
Chapter 11
Installation and Wiring
Figure 11Table 11
11 – 1
Chapter 10
Installation and Wiring
In this chapter you will learn how to:
•
Mount the DL40 in a panel
•
Wire the DL40 to your control system
The following figures provide panel cutout dimensions and overall
dimensions for the DL40.
You can mount the DL40 in a custom panel or enclosure. When the DL40 is
properly installed, the faceplate of the DL40 provides a NEMA Type 12, 13,
and 4X (indoor) enclosure integrity.
To install the DL40, perform the following steps:
1. Cut and drill the appropriate mounting holes in the enclosure or panel.
2. Remove the six mounting nuts from the six mounting studs on the DL40.
3. Position the DL40 in the panel or enclosure mounting hole.
4. Install and tighten the six mounting nuts to a torque of 14 in
•
lbs (1.6N
•
m)
each.
Chapter Objectives
Mounting the DL40