Rockwell Automation 2706 DL40 HARDWARE USER MANUAL - Manual (Page 141)

Chapter 12
DIP Switch Settings
12 – 6
If LAST STATE is disabled, the DL40 will clear the display, and display the
error message.
Select Button Enable (Switch #9)
If the Select Button Enable DIP switch is set to ON, then the [SELECT]
button on the faceplate of the DL40 is enabled. If the Select Button Enable
DIP switch is set to OFF, then the [SELECT] button on the faceplate of the
DL40 is disabled.
Setting Switch Bank #3
Use Switch Bank #3 to set the serial address. The serial address refers to the
address used for triggers received from the serial RS-485 port or computer
keyboard.
Table 12.I gives the switch functions and settings for Switch Bank #3.