Rockwell Automation 2706 DL40 HARDWARE USER MANUAL User Manual
Page 35
Chapter 3
The Run Mode – Remote I/O
3 – 9
Send DL40’s Real Time Clock or Date Data
to a PLC
Same as Message/Variable/Slave Run Mode; however, see page 10-26 & 27
for more information.
Put Messages on the Historical Events Stack
Same as Message/Variable/Slave Run Mode but, in addition, the Bit Image
Table is put on the stack each time it is changed regardless of whether or not
the stack attribute is set.
Note: If the message’s Historical Events Stack attribute is set, message data
will be placed on the stack
Send Messages to the Slave Address Specified as a Message Attribute
Refer to Chapter 4 for information.
Note: If the message’s print attribute is set, the message will be printed once
for each time it is displayed or redisplayed.
Note: To send any message to a slave,
Port Use
of the RS-485 Port must be
set to
DL Slaves
. Refer to Chapter 6 for more information.