Rockwell Automation 2706 DL40 HARDWARE USER MANUAL - Manual (Page 54)

Chapter 6
Other Operating Modes
6 – 8
WRITE COMPLETE
PRESS ANY KEY
Pressing any key or front panel push button will return the DL40 to the
WRITE TO MODULE prompt.
If you stop the write (pressing [ESC] or [MSG ACK] ), the DL40 will
display:
USER ABORTED WRITE
PRESS ANY KEY
Pressing any key or front panel push button will return the DL40 to the
WRITE TO MODULE prompt.
Error Messages
NO MODULE INSTALLED
PRESS ANY KEY
If the Memory Module is not properly installed.
MODULE TOO SMALL
If module memory is not large enough to hold the entire application memory.
ERROR WRITING MODULE
If the Memory Module is bad.
Read from Module
When the READ FROM MODULE prompt is displayed, enter [Y] [
↵
] from
the DL40 Keyboard Port or [
↵
] from the front panel. DL40 will display:
INTERNAL MEMORY WILL BE ERASED – – OK?
Important: If you enter [Y] [
↵
] or [
↵
] the contents of the DL40’s internal
application memory will be erased even if you decide to abort the read by
pressing the
[ESC] key or [MSG ACK] push button.
Press [Y] [
↵
] from the keyboard or [
↵
] from the front panel and uploading
the application stored on the Memory Module will begin. After uploading is
finished, the DL40 will display:
READ COMPLETE
PRESS ANY KEY
Pressing any key or front panel push button will return the DL40 to the
READ FROM MODULE prompt.
If you stop the read (pressing [ESC] or [MSG ACK] ), the DL40 will
display:
USER ABORTED READ