Rockwell Automation 2706 DL40 HARDWARE USER MANUAL - Manual (Page 55)

Chapter 6
Other Operating Modes
6 – 9
Pressing any key or front panel push button will return you to the READ
FROM MODULE prompt.
Error Messages
NO MODULE INSTALLED
PRESS ANY KEY
If the Memory Module is not properly installed.
MEMORY TOO SMALL
If DL40 internal application memory size is not large enough to hold the
entire application stored on the Memory Module.
ERROR WRITING MEMORY
If the DL40’s internal memory circuitry is bad.
Write to Tape
Allows the contents of the DL40’s internal application memory to be written
(downloaded) to an Allen–Bradley 1770-SA or 1770-SB tape recorder.
When the WRITE TO TAPE prompt is displayed, press [Y] [
↵
] from the
keyboard or [
↵
] from the front panel. The DL40 will display:
START TAPE, BAUD = __ __ __ __
PRESS ANY KEY
Note: The baud rate of the DL40 and the tape recorder must match.
Press any key from the keyboard or any push button from the front panel and
downloading to the tape recorder will begin.
The DL40 will display:
SENDING XXXX OF YYYY
Where:
XXXX = Message being downloaded (first, second, third, etc.)
YYYY = Total number of messages in the file
When the entire file is downloaded, the DL40 will display:
WRITE COMPLETE
XXXX GOOD YYYY FAIL
Showing successful and unsuccessful message writes.
If you stop the write (pressing [ESC] or [MSG ACK] ), the DL40 will
display: