Rockwell Automation 2706 DL40 HARDWARE USER MANUAL - Manual (Page 84)

Chapter 8
Serial Communications
8 – 7
Note: Only for Messages triggered via RS-485 Port. Format for messages
triggered via Remote I/O in Chapter 10.
After the message completes running, ASCII data is returned using the
following format:
[CTRL][B] ASCII Data
Backslash
( \ )
Msg.
Number
Backslash
( \ )
DL40
Address
[
↵
]
where:
Data Acceptable Values
ASCII Data
1 to 20 ASCII characters. Data is for the latest message sent to
the specified DL40.
Message
Number
1 to 4 ASCII digits (1 to 9999).
Number of the message which received [CTRL][X] (ASCII Input)
data.
DL40 Address
1 to 3 digits (0 to 127)
Address of the DL40 on which the message was displayed.
Inputting ASCII Input Data via
the RS-485 Port