Rockwell Automation 2706 DL40 HARDWARE USER MANUAL - Manual (Page 61)

Chapter 6
Other Operating Modes
6 – 15
Via the DL40 Keyboard Port
When you enter the Set Clock function, you will receive the following
prompts (one at a time):
Parameter Available choices
MONTH Jan to Dec – Use the spacebar to cycle
through the months, then press [
↵
] when
the correct entry is shown.
DAY 1 to 31 followed by [
↵
]
YEAR 0 to 99 followed by [
↵
]
TIME FORMAT Use the spacebar to toggle between time formats.
Press
[
↵
] when the correct entry is shown.
Select [AM/PM] or [24 hr]
HOUR 1 to 12 or 1 to 23 followed by [
↵
]
IS THIS AM Only for 12-hour clocks. Enter [Y] or [N] followed
by
[
↵
]
MINUTES 0 to 59 followed by [
↵
]
SECONDS 0 to 59 followed by [
↵
]
After SECONDS are entered, the new clock data will be saved and the
DL40 will display the SET CLOCK prompt.
If Set Clock is aborted (by pressing [ESC] ), real time clock data will remain
unchanged.
Show Clock
Note: Show Clock is only available when the menus are entered via the
keyboard
[CTRL][C] ; it is not available via the front panel push button
menus.
This displays real time clock values in the following format:
HH:MM:SSA
DAY MON YR
HH = hour MM = minute SS = second
A (AM) or P(PM) not displayed if 24 hour format is used.