Rockwell Automation 7000 PowerFlex Medium Voltage AC Drive (B Frame) Commissioning - ForGe Control - Manual (Page 24)

24 Rockwell Automation Publication 7000-IN012B-EN-P - June 2014
Chapter 3 Commissioning Preparations
Computer Requirements and Software
• Laptop computer (486 or higher installed with Microsoft (MS) Windows)
• Microsoft HyperTerminal (Provided with MS Windows)
(1)
• Rockwell Automation Software (RS) drive tools (Optional)
• RS Logix
(2)
• Required computer cables
– 9-Pin Null Modem
(3)(1)
– 9-Pin Serial
(3)
– Ethernet cable
(4)
– Remote I/O (SCANport DeviceNet…)
(5)
– PLC Communications Cable
(2)
Additional Required
Resources Prior to scheduling your drive commission, ensure you have the following:
• Functional specifications for the drive to be commissioned (generally
available from the online MV Literature Library).
• Any commissioning notes for this customer/installation, available from the
Rockwell Automation Application Specialist or Project Manager.
• Self-powered gate driver board test power cable wire harness
(Part no. 80018-298-51) supplied with SCR rectifier drives only.
• SPS test power cable wire harness (part no. 80018-695-51) supplied with
SPS rectifier drives only
• Rockwell Automation electrical and mechanical diagrams for each drive
(also available through ShopView/SAP).
• PLC program (if supplied with a PLC; materials available from the MV
intranet website using the order number as a reference).
• Commissioning data sheets.
• All required manuals (see below for list).
If any of the above information is not available prior to the time of
commissioning, please contact the Rockwell Automation Project Manager or the
factory.
(1) Only required if drive does not have PFNI (PowerFlex 7000 Netserver Interface).
(2) Only required when PLC has been provided with the drive.
(3) Refer to Publication 7000-UM202_-EN-P .
(4) Only required when drive has PFNI.
(5) Only required when Remote I/O has been provided with the drive.