Running your program – Rockwell Automation GMLC Reference Manual User Manual

Page 151

Advertising
background image

Publication GMLC-5.2 - November 1999

114

Configuring Axis Use

Note:

Note: For Compact, Integrated, and Basic controllers only.

5. Saving Changes

•

Save to Power-up – Saves changed working values as the power-
up (or start-up) values in the controller

•

Save – Saves changed working values as the power-up values in
the Gains dialog box

Note: This does not change the power-up values in the controller until

you download with axis/drive data selected, download via the
Apply page, or press the Save to Power up in the Adjust Gains
page.

•

Save then select OK in the Configure Axis Use dialog box–
Saves changed working values as offline power-up values

•

Cancel – Not save the changes

Note: Generally, you will not need to modify the self-tuned parameters

for axis gains.

Running your Program

To control your program from the Adjust Gains page, use the following:

•

Start Program – Starts the application program in the controller.

•

Stop Program – Stops the application program in the controller
with the feedback remaining enabled and motion stopping at
100% of the deceleration rate.

•

Kill Control – Kill the control with the feedback disabled and
motion stopping immediately on all axes.

•

Reset All – Resets the values on this page to the controller’s
power-up (start-up) values.

Advertising