Rockwell Automation GMLC Reference Manual - Manual (Page 723)

Publication GMLC-5.2 - November 1999
686 Using the RIO Adapter Option
Configuring the RIO Adapter
Configure the RIO adapter—including baud rate, rack size, and rack
address—using either the motion controller’s built-in setup menus or the
RIO page of the Configure Control Options dialog box in GML
Commander. See RIO Addressing in this chapter for more information on
configuring the RIO adapter for your application.
Enabling RIO in GML Commander
To enable RIO:
1. From the menu bar, select Configure. The Configure menu appears.
2. Select Control Options. The Configure Control Options dialog box
appears.
3. In the General page of the Configure Control Options dialog box,
select RIO.
4. Select Adapter to allow the RIO adapter features of GML Com-
mander to be used in your diagram.
5. See Online Help for instructions on completing each of the Configure
Control Options pages.