Rockwell Automation GMLC Reference Manual - Manual (Page 68)

Publication GMLC-5.2 - November 1999
Defining a Diagram’s Configuration Settings 31
Note: All options on this menu are part of the setup procedure. You can
use these options later during testing and monitoring processes to
make changes.
2. Select Control Options. The Configure Control Options dialog box
appears.
3. To set the Control Options, follow the steps in the following section.
Setting Control Options
You configure the control options for the controller from the Configure
Control Options dialog box.
Basic information required for all diagrams is presented on the General,
Axes, and Interface tabs. Selections on the General tab can display
additional tabs containing further options.
The tasks performed from this menu are:
• Setting the control type
• Setting the basic communications interfaces
• Setting the application options
• Defining the setups password
Setting General Control Options
To set control options for your controller:
1. Select Configure from the menu bar. The Configure menu appears.
2. Select Control Options. When the Configure Control Options dialog
box displays, the basic tabs appear. The example below shows this
dialog box before configuration settings are selected.