Rockwell Automation GMLC Reference Manual - Manual (Page 465)

Publication GMLC-5.2 - November 1999
428 Display and Operator Interface Blocks
All faults—global, system or axis—are displayed as a text message as
shown in the following tables.
Motion Controller Faults
Runtime
Display
Description Global Axis
1394
Axis System
AXES OK No Faults ✔
AXIS OK No Faults ✔ ✔
AXL FLT AxisLink Virtual Axis Link
Lost ✔ ✔
AXL FLT AxisLink Virtual Axis Fault ✔ ✔
BUS FLT Bus Loss Fault ✔ ✔
BOV FLT Bus Over Voltage Fault ✔
CTR FLT Control Power Loss ✔
DH FLT DH-485 Fault ✔
DRV FLT Drive Fault ✔ ✔
ENC FLT Encoder Fault ✔
ENC FLT Encoder Noise or Loss Fault ✔
ENC FLT Encoder/Resolver Fault ✔
ERR FLT Servo Error Fault ✔ ✔
ERR FLT Position Error Fault ✔
GND FLT Ground Fault ✔
HRD FLT Hard Travel Limit Fault ✔ ✔ ✔
I-T FLT It Fault ✔
MEM FLT Setup Data Memory Fault ✔
MTR FLT Motor Thermal Fault ✔
NO AXES Not Installed ✔