Rockwell Automation SB3000 Configuration and Programming User Manual
Page 116
Index-2
SB3000 Drive Configuration and Programming
VAR feedback (volts * amps), 3-40
voltage feedback (volts rms), 3-39
G
Generating drive parameter files, 2-8
H
Hex Value, 3-3
I
Interrupt status and control registers, 3-59 to 3-61
interrupt status control, 3-59 to 3-60
scans per interrupt, 3-61
Interrupts, 4-3, 4-8
Introduction, 1-1 to 1-2
L
LED indicator, 3-3
Local tunable variables, 4-6 to 4-7, B-1 to B-3
calculating local tunable values, 4-7
M
Meter ports
parameters, 2-7
port 1 registers, 3-55
port 2 registers, 3-56
port 3 registers, 3-57
port 4 registers, 3-58
port selection, 2-6 to 2-7
resolution of data, 3-54 to 3-58
setup registers, 3-53 to 3-58
Motor data entry, 2-5
N
Nth scan interrupts, 3-50
O
On-line operation, 5-1 to 5-3
deleting UDC tasks, 5-3
loading drive parameters, 5-1 to 5-2
loading the UDC operating system, 5-1
loading UDC tasks, 5-1 to 5-2
running UDC tasks, 5-2
stopping UDC tasks, 5-2
UDC information and error logs, 5-3
P
Power module parameter entry, 2-4 to 2-5
Power system configuration, 2-4 to 2-5
Pre-charge sequencing, E-1 to E-4
state diagram, E-4
Printing drive parameters, 2-8
R
Rail I/O port registers, 3-6 to 3-8
check bit fault counter registers, 3-7 to 3-8
fault registers, 3-7 to 3-8
Range, 3-3
Register Name, 3-3
Register Numbers, 3-3
Register reference
see Drive Register Reference
Register/bit reference conventions, 3-3 to 3-5
Related publications, 1-1
Restricted drive type combinations, 2-2
Run permissive logic, 4-9
S
Screens for parameter entry
meter port selection, 2-6
power module data, 2-4
Sug. Var. Name, 3-3
Supported SB3000 power modules, 2-5
Synchronous rectifier system diagram, E-2
U
UDC Error Code, 3-3
UDC module
adding a UDC module, 2-1 to 2-2
initiate change in setup register, 3-54
meter port setup registers, 3-53 to 3-58
test I/O registers, 3-51 to 3-58
test switch inputs register, 3-51 to 3-52
UDC task scan, 3-48, 4-2
UDC/PMI communication status registers, 3-9 to
3-16
PMI communication status, 3-12 to 3-15
PMI CRC error count, 3-15
PMI format error count, 3-15