Rockwell Automation SB3000 Configuration and Programming User Manual
Page 62
3-44
SB3000 Drive Configuration and Programming
Parallel Power Module C Status Register (Continued)
221/1221
Phase W-Upper IOC C
Bit 2
The Phase W-Upper C status bit is set if an
IOC or DSAT fault occurs in Power Module
C’s phase W, upper power device.
Hex Value:
0004H
Sug. Var. Name:
W_UPC@
Access:
Read only
UDC Error Code:
N/A
LED:
N/A
Phase U-Lower IOC C
Bit 3
The Phase U-Lower IOC CC status bit is set
if an IOC or DSAT fault occurs in Power
Module C’s phase U, lower power device.
Hex Value:
0008H
Sug. Var. Name:
U_LOC@
Access:
Read only
UDC Error Code:
N/A
LED:
N/A
Phase V-Lower IOC C
Bit 4
The Phase V-Lower C status bit is set if an
IOC or DSAT fault occurs in Power Module
C’s phase V, lower power device.
Hex Value:
0010H
Sug. Var. Name:
V_LOC@
Access:
Read only
UDC Error Code:
N/A
LED:
N/A
Phase W-Lower IOC C
Bit 5
The Phase W-Lower C status bit is set if an
IOC or DSAT fault occurs in Power Module
C’s phase W, lower power device.
Hex Value:
0020H
Sug. Var. Name:
W_LOC@
Access:
Read only
UDC Error Code:
N/A
LED:
N/A
Intelligent Power Module C
Bit 6
The Intelligent Power Module C bit is set to
indicate that a DSAT (shoot-through) fault
has occurred in Power Module C.
Hex Value:
0040H
Sug. Var. Name:
IPUC@
Access:
Read only
UDC Error Code:
N/A
LED:
N/A
Bits 0 - 5 of this register should be checked to identify the device in which the fault
occurred.