Rockwell Automation SB3000 Configuration and Programming User Manual
Page 26
3-8
SB3000 Drive Configuration and Programming
Table 3.5 – Fault Register and Check Bit Fault Counter Register
Usage for a Digital I/O Rail or 4-Input Analog Rail Module
Drive A
Registers
Drive B
Registers
Description
4
16
Port 0 Fault Register
10
22
Port 1 Fault Register
Bit 0: Analog Channel 0 Input Over-Range
Bit 1: Analog Channel 0 Input Under-Range
Bit 2: Analog Channel 1 Input Over-Range
Bit 3: Analog Channel 1 Input Under-Range
Bit 4: Analog Channel 2 Input Over-Range
Bit 5: Analog Channel 2 Input Under-Range
Bit 6: Analog Channel 3 Input Over-Range
Bit 7: Analog Channel 3 Input Under-Range
Bit 8: No device plugged into a configured port
Bit 9: Bad ID code: device other than rail plugged into port
Bit 10: Bad rail communication check bits received
Bit 11: PMI interface not ready
5
17
Port 0 Check Bit Fault Counter Register
11
23
Port 1 Check Bit Fault Counter Register
These registers can be reset by setting bit 9 of the Drive
Control register (100/1100)
Table 3.6 – Fault Register and Check Bit Fault Counter Register
Usage for a 2-Output/2-Input Analog Rail Module
Drive A
Registers
Drive B
Registers
Description
4
16
Port 0 Fault Register
10
22
Port 1 Fault Register
Bit 4: Analog Channel 2 Input Over-Range
Bit 5: Analog Channel 2 Input Under-Range
Bit 6: Analog Channel 3 Input Over-Range
Bit 7: Analog Channel 3 Input Under-Range
Bit 8: No device plugged into a configured port
Bit 9: Bad ID code: device other than rail plugged into port
Bit 10: Bad rail communication check bits received
Bit 11: PMI interface is not ready
5
17
Port 0 Check Bit Fault Counter Register
11
23
Port 1 Check Bit Fault Counter Register
The register can be reset by setting bit 9 of the Drive
Control register (100/1100)