Rockwell Automation SB3000 Configuration and Programming - Manual (Page 14)

2-4 SB3000 Drive Configuration and Programming
Step 3. Use the Configure parameters option to access the Parameter Entry screens.
Assuming you are configuring an SB3000 Synchronous Rectifier, you can
access two screens: Power Module Data and Meter Port selection. These
screens are described in detail in the following sections.
Note that the AutoMax slot number of the UDC module is shown at the top of
the screens. The screens prompt for specific information depending upon
the item that is being configured.
Step 4. When you have made entries for the drive parameters on all of the parameter
entry screens, you should select the “Verify” option displayed at the bottom of
the screen. If any of the values you entered are invalid or out of range, the
parameter that is invalid will be highlighted so that you can change the value.
When you have finished entering drive parameters, select “Save” to save the
values to the database.
2.2.1 Power Module Parameter Entry
The Power Module Parameter Entry screen allows entry of specific information about
the power system configuration, the Power Module, and the motor. See figure 2.1.
Figure 2.1 – Power Module Parameter Entry Screen
Power System Configuration
• AC Line Voltage (Volts RMS) (Range: 200V to 500V)
The AC line voltage parameter is the nominal AC RMS voltage supplying the
SB3000 Synchronous Rectifier and being converted to the DC bus voltage. There is
no default value. You must enter a value within the specified range.