Bio-Rad BioLogic LP System - Manual (Page 24)

3.0 SYSTEM CONNECTIONS
When setting up the system, consider the amount of bench space available, the instruments to be used with
the system, and the devices to be used with the System Rack.
The BioLogic LP can be set up wherever there is available bench space and sufficient power outlets, includ-
ing in 4° cold rooms or cold boxes. When used in a cold environment, it is recommended that you leave
system power “ON” to minimize condensation.
All BioLogic LP systems will include as a minimum the following:
• Controller • Proportioning valve/Mixer module
• System Rack (single tray configuration) • MV-6 Inject Valve
• UV Optics Module • Fittings kit
• Conductivity Flow Cell • Tubing
Your BioLogic LP system may include components or instruments not listed above. Refer to the separate
supporting documentation for each of the following types of devices:
• Bio-Rad Model 2128 or Model 2110 Fraction Collector
• Bio-Rad Model 1327 Chart Recorder
• additional valves
• instruments not purchased from Bio-Rad, such as a generic fraction collector or chart recorder
Figure 9. Example of a BioLogic LP System
17
System Connections
SV-5 BUFFER SELECT
MV-6 INJECT VALVE
UV OPTICS MODULE
CONDUCTIVITY FLOW CELL
PROPORTIONING VALVE
AND MIXER MODULE
MODEL 1327
CHART RECORDER
BIOLOGIC LP
CONTROLLER
SYSTEM RACK
MODEL 2128 FRACTION
COLLECTOR
ECONO COLUMN
SV-3 DIVERTER VALVE
SV-3 BYPASS VALVE