Bio-Rad BioLogic LP System - Manual (Page 61)

54
System Operation
Table 13. (continued)
Program Mode Operation: New Method
Reference Description
appropriate instrument key at any time, except while actually
viewing and editing a method. Although the Chart Recorder is
not programmed, it automatically records all runs.
Save Method screen: This screen allows the following choic-
es:
•
Save: This allows a name to be entered for the method
and the method to be saved in permanent storage. For a
description of how to enter method names see section
5.3.7.
Note: All methods which have names other than “<unti-
tled>” have been saved in permanent storage.
• No Save: This allows the method to remain the current
method and for it to be run without saving it in permanent
storage. This option is typically used when a method will
never be repeated or when 50 methods are already stored
in permanent memory. A method which is not saved will
always be named “<untitled>”.
Note: The “<untitled>” method loaded as the current
method is not lost when the power is shut off and remains
the current method when power is restored.
Method: <untitled> Time: 10 min
Name and Save this method or use the
method without saving as <untitled>
SAVE
NO SAVE
N1a
PM
(Enter Method’s
name before
returning to PM.
For further dis-
cussion refer to
discussion at
start of section
5.3.7.)
Note: If you selected Volume as the unit of mea-
sure, the top line of this screen would display:
Method: <untitled>
Volume: 10 ml.