Dell PowerEdge FX2/FX2s - Manual (Page 100)

PP (KB) (KB)
(KB) (KB)
---------------------------------------------------------------
-------------------
0 0 3822 1912 832
450
Dell(conf)#
dcbx version
Configure the DCBX version used on the interface.
Syntax dcbx version {auto | cee | cin | ieee-v2.5}
To remove the DCBX version, use the no dcbx version {auto | cee | cin
| ieee-v2.5} command.
Parameters
auto | cee | cin
| ieee-v2.5 Enter the DCBX version type used on the interface, where:
• auto: configures the port to operate using the DCBX
version received from a peer.
• cee: configures the port to use CEE (Intel 1.01).
• cin: configures the port to use Cisco-Intel-Nuova (DCBX
1.0).
• ieee-v2.5: configures the port to use IEEE 802.1az
(Draft 2.5).
Defaults Auto
Command
Modes INTERFACE PROTOCOL LLDP
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Usage
Information
DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.
Configure DCBX operation at the INTERFACE level on a switch or globally on the
switch. To verify the DCBX configuration on a port, use the show interface
dcbx detail command.
100