Dell PowerEdge FX2/FX2s - Manual (Page 253)

stack-unit iom-mode
Toggle the FN I/O Aggregator operating mode between programmable multiplex, stand-alone, stack, and
VLT modes.
Syntax stack-unit <unit-number> iom-mode [programmable-mux | stack |
standalone | vlt]
Parameters
unit number
<0-5> Enter the number of the member stack unit. The range is
from 0 to 5.
programmable
-mux Enable programmable multiplex mode.
stack Enable stack mode.
standalone Enable stand-alone mode.
vlt Enable virtual link trunking mode.
Defaults standalone
Command
Modes
• CONFIGURATION
Command
History
Version 9.6.
(0.0) Supported on the FN I/O Aggregator.
Usage
Information This command is supported on the FN410S and the FN410T Aggregators.
Example
Dell(conf)#stack-unit 0 iom-mode stack
% You are about to stack your IOA module, please reload the IOA
and then plug in the stacking cable for the changes to take
effect.
Dell(conf)#
Dell#
Related
Commands
reload — Reboots the operating system.
show system — displays the current status of all stack members or a specific
member.
show system stack-unit iom-mode
Displays the current iom-mode (stack/standalone) and the mode configured after next reboot.
Syntax show system stack-unit unit-number iom-mode
253