Stacking commands – Dell PowerEdge FX2/FX2s User Manual
Page 418
Command
Modes
CONFIGURATION
Command
History
Version 9.4(0.0)
Supported on the FN I/O aggregator.
Usage
Information
The key configured on the switch must match the key configured on the RADIUS
server daemon.
If you configure the key parameter in the radius-server host command, the
key configured with the radius-server key command is the default key for all
RADIUS communications.
Related
Commands
— configures a RADIUS host.
show privilege
View your access level.
Syntax
show privilege
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.4(0.0)
Supported on the FN I/O aggregator.
Example
Dell#show privilege
Current privilege level is 15
Dell#
Stacking Commands
Stacking is supported on the FN410S and FN410T cards with ports 9 and 10 as the stack ports. Stacking is
limited to six Aggregators in the same or different chassis in a single stack.
Stacking provides a single point of management and NIC teaming for high availability and higher
throughput. To configure an Aggregator stack, you must use the CLI.
The stacking commands are always available and operational. You can use the commands to pre-
configure an Aggregator, so that the configuration settings are invoked when the Aggregator is attached
to other Aggregator blades.
For more information about using the Aggregator stacking feature, refer to the Stacking Aggregators
chapter in the Dell Networking OS Configuration Guide for the FN I/O Aggregator.
You can use the following commands to manage a stack of Aggregator I/O modules:
•
•
418