Dell PowerEdge FX2/FX2s - Manual (Page 136)

• name
• show config (from INTERFACE VLAN mode)
• show vlan
• vlan tagged
• vlan untagged
auto vlan
Change the port to auto or admin vlan mode (enable or disable all auto VLANs).
Syntax auto vlan
To remove membership from 4K VLAN, use the no auto vlan command.
Defaults none
Parameters
description Enter a text string description to identify the VLAN (80
characters maximum).
Command
Modes INTERFACE
Usasge
Information The auto vlan command adds the port as untagged to default vlan and tagged to
all other 4094 VLAN.
This command is available only in Standalone mode.
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
clear counters
Clear the counters used in the show interfaces commands for VLANs, and physical interfaces, or
selected ones.
Syntax clear counters interface
Defaults Without a specific interface specified, the command clears all interface counters.
Parameters
interface (OPTIONAL) Enter any of the following keywords and slot/
port or number to clear counters from a specified interface:
• For the management interface on the stack-unit, enter
the keyword managementethernet followed by slot/
port information. The slot and port range is 0.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
136