Dell PowerEdge FX2/FX2s - Manual (Page 260)

end-day Enter the number of the day. The range is from 1 to 31. You
can enter the name of a month to change the order of the
display to time day month year.
end-month Enter the name of one of the 12 months in English. You can
enter the name of a day to change the order of the display to
time day month year.
end-time Enter the time in hours:minutes. For the hour variable, use
the 24-hour format; example, 17:15 is 5:15 pm.
end-year Enter a four-digit number as the year. The range is from 1993
to 2035.
offset (OPTIONAL) Enter the number of minutes to add during the
summer-time period. The range is from 1 to1440. The
default is 60 minutes.
Defaults Not configured.
Command
Modes CONFIGURATION
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Related
Commands
clock summer-time recurring — sets a date (and time zone) on which to convert
the switch to daylight saving time each year.
show clock — displays the current clock settings.
clock summer-time recurring
Set the software clock to convert to daylight saving time on a specific day each year.
Syntax clock summer-time time-zone recurring [start-week start-day
start-month start-time end-week end-day end-month end-time
[offset]]
To delete a daylight saving time zone configuration, use the no clock summer-
time command.
Parameters
time-zone Enter the three-letter name for the time zone. This name is
displayed in the show clock output. You can enter up to
eight characters.
start-week (OPTIONAL) Enter one of the following as the week that
daylight saving begins and then enter values for start-day
through end-time:
260