Dell PowerEdge FX2/FX2s - Manual (Page 319)

4 - -
5 - -
6 - -
7 - -
8 - -
show stack-unit stack-ports pfc details
Displays the PFC configuration applied to ingress traffic on stacked ports, including PFC Operational
mode on each unit with the configured priorities, link delay, and number of pause packets sent and
received.
Syntax show stack-unit {all | stack-unit} stack-ports {all | port-
number} pfc details
Parameters
stack-unit Enter the stack unit.
port-number Enter the port number.
Command
Modes CONFIGURATION
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Example
Dell(conf)# show stack-unit all stack-ports all pfc details
stack unit 0 stack-port all
Admin mode is On
Admin is enabled, Priority list is 4-5
Local is enabled, Priority list is 4-5
Link Delay 45556 pause quantum
0 Pause Tx pkts, 0 Pause Rx pkts
stack unit 1 stack-port all
Admin mode is On
Admin is enabled, Priority list is 4-5
Local is enabled, Priority list is 4-5
Link Delay 45556 pause quantum
0 Pause Tx pkts, 0 Pause Rx pkts
Dynamic Host Configuration Protocol
Dynamic host configuration protocol (DHCP) is an application layer protocol that dynamically assigns IP
addresses and other configuration parameters to network end-stations (hosts) based on configuration
policies determined by network administrators.
An Aggregator can operate as a DHCP client. As a DHCP client, the Aggregator requests an IP address
from a DHCP server.
319