Dell PowerEdge FX2/FX2s - Manual (Page 361)

links before it can be declared as up. For example, if the required minimum is four,
and only three are up, the LAG is considered down.
Internet Group Management Protocol (IGMP)
The IGMP commands are supported by the Dell Networking operating software on the Aggregator.
This chapter contains the following sections:
• IGMP Commands
• IGMP Snooping Commands
IGMP Commands
Dell Networking OS supports IGMPv1/v2/v3 and is compliant with RFC-3376.
Important Points to Remember
• IGMPv2 is the default version of IGMP on interfaces. You can configure IGMPv3 on interfaces. It is
backward compatible with IGMPv2.
• There is no hard limit on the maximum number of groups supported.
• IGMPv3 router interoperability with IGMPv2 and IGMPv1 routers on the same subnet is not supported.
• An administrative command (ip igmp version) is added to manually set the IGMP version.
• All commands previously used for IGMPv2 are compatible with IGMPv3.
ip igmp group-join-limit
To limit the number of IGMP groups that can be joined in a second, use this feature.
Syntax ip igmp group-join-limit number
Parameters
number Enter the number of IGMP groups permitted to join in a
second. The range is from 1 to 10000.
Defaults none
Command
Modes CONFIGURATION (conf-if-interface-slot/port)
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
ip igmp querier-timeout
Change the interval that must pass before a multicast router decides that there is no longer another
multicast router that should be the querier.
Syntax ip igmp querier-timeout seconds
361